Solar Panel Cable & Connector Set – Quick Connect Kit

This solar panel cable and connector set greatly simplifies the installation of a solar module to your electrical system. Whether you’re outfitting a boat, an RV, or a stationary solar project, you no longer need to worry about selecting and crimping the right cables and connectors – this product provides a ready “plug-and-play” solution. The kit includes two conductors (positive and negative) with factory-crimped solar connectors on each end: on the panel side, typical MC4 connectors compatible with the output leads of most PV panels on the market, and on the controller/battery side, stripped wire ends (or optionally pre-fitted lugs, depending on the version). Simply plug the connectors into your panel, connect the bare ends into your solar charge controller (observing polarity), and the system is ready to go.

Reliability and safety are the key advantages of this kit. The included solar connectors provide a stable, low-resistance connection that’s weatherproof. They are industry-standard MC4 type, meaning they mate perfectly with the connectors pre-installed on most panels. Once connected, they lock together, preventing accidental disconnection due to boat vibration or wind tugging. At the same time, if you need to service or move the panel, unlocking them is easy by depressing the built-in clips (or using an MC4 spanner if available), without damaging the cables.

The cables in the set are appropriately gauged (typically around 4 mm² or AWG11, depending on the model) – ensuring they can carry the current from the panel to the controller with minimal loss or overheating. Their insulation is double-layer and UV-resistant, meaning they can withstand years of harsh sun without cracking or degrading. This is especially important in marine settings, where sunlight, salt air, and water spray can quickly deteriorate ordinary wires – this kit is built with those factors in mind.

• Quick installation: With this kit, setup time is drastically reduced. You don’t need to crimp connectors or use a soldering iron on-site – everything is pre-made. This is particularly handy when adding a solar panel on a RV roof, a yacht’s deck, or any hard-to-reach spot – just plug in the connectors and tighten down the controller terminals.
• Flexible use: The cable set works for both permanently installed panels and portable/deployable panels that you use only when needed. For example, if you have a foldable solar panel for your boat, this kit lets you connect it quickly while at anchor and disconnect in seconds when you set sail, without any confusion over wiring.
• Safety first: The connectors are designed to prevent cross-polarity – the male and female ends are distinctly keyed and labeled. Even novice users can make the connection confidently. Moreover, the waterproof nature of the connections ensures that rain or splashes won’t short out your system. The cables have thick insulation, protecting against mechanical damage or chafing when routed through holes or along rails.
• Universal use: Although originally intended for marine applications (Eval is a brand oriented toward marine gear), this solar cable kit can be used anywhere you have a solar panel of similar wattage – in the garden to power a fountain or lights, at a campsite for an RV, for temporary setups at outdoor events, etc. It will save time and improve the reliability of connections in all those scenarios.
• Standards compliant: The MC4 connectors in the kit are rated and tested for safety and performance. They can handle high current (typically 30+ A) and up to 1000V DC, which is far above the requirements of small 12V/24V systems – giving extra peace of mind regarding their robustness. The cables are certified PV-grade solar cables, meaning the product meets the technical standards for photovoltaic installations.